12 years professional CNC and laser cutting machine manufacturer

Mesa of flat plane adjustment problems

by:Ludiao     2020-09-30
The adjustment appears unavoidably some short have to repeatedly adjust other projects. Below is one where the pressure to the plane of mesa adjustment problems. 1, the loading bay and knife axis is not parallel: on chute platform mat copper, where low pad which side. 2, discharging machine and knife axis is not parallel, pad in the side of the supporting plane low copper wire and adjust the top ( Only a small range adjustment) , loosen the discharging platform fasteners, adjust the discharging platform in position in the plane of the support ( Or so) 。 3, discharging machine and knife shaft height mismatch: loosen the discharging platform fasteners, adjust the discharging platform in position in the plane of the support ( Up and down) , adjust the top wire ( Tighten the platform relative knife shaft is reduced, pay attention to the parallel relationship will change at the same time in and out of loading) 。 4, front-rear mesa not parallel ( Is mainly the vertical knife axis parallel) Add the gasket: a chute feed on both sides, respectively, at the same time in the upper or lower; Adjust the discharging the top wire ( Will change the knife axis and loading height) 。 The above is the problem about the adjustment of the press flat plane mesa, hope to be of help.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...