One, just a carving is not deep, first check the laser tube is appropriate, the support of the light intensity set is too small, light path deviation, the focal length is correct, the lens surface scratches and dirt, if more than the normal need consultation requires information and technical personnel.
Second, the start is very good, not deep processing after a moment, the first to check the laser tube is reasonable, the support of the water temperature is more than 30 degrees, the lens when the work is fever, cooling water flow is normal, the cooling water is clean, if the above normal consulting requires information and technical personnel will be needed.
Three light, high pressure and discharge, check whether there is high pressure head smudgy and moist, away from the machine metal parts are too close, the other is the laser power supply cable is falling from the terminal, high pressure connection devices connected is fracture and damage, if the above normal consulting requires information and technical personnel will be needed.
Four, laser tube to break, crack, water cooled off 1 set, if the water temperature control in 25
Within the scope of 30 degrees, cold area of cooling water can't freeze, especially after the laser machine downtime can't keep the water stored in the laser tube.
Whether 2, glow in the condition of water conservation work, (
Test the laser tube under the condition of the water, can shine)
3, water pipes have been playing down the phenomenon.
4 a drum, laser tube is stored.