Woodworking engraving machine maintenance: want to engraving machine parts always keep a good state, adhere to the regular maintenance is very important.
1, 10 hours a day under the continuous running time, guarantee the normal work of the cooling water clean and the water pump, must not water shortage phenomenon in a spindle motor, regular replacement of cooling water, in order to prevent the water temperature is too high.
2, each machine after use, should pay attention to clean up, make sure the platform and the rotation system of powder is clean, regular lubrication oil in transmission system.
3, electrical maintenance checks, must cut off power supply, to monitor display and main circuit power light goes out after may.
4, carving machine use about three months to inspect the fasteners, longmen connection on both sides of the screw, screw nut fastening screws, fastening screws for fastening on both sides of the motor.
5, computer and control box if it is too dirty, dust is too much, will affect the normal operation of the engraving machine.